Features: 100% New and High Quality 1 Year Warranty Type: Crankshaft Crank Puller Removal Tool Color:As shown in the picture Material: Carbon Steel Function: Specially design to hold the crankshaft pulley and install or remove the cramkshaft bolt. removal and install crankshaft damper. The crankshaft pulleys used on these engines are tightened to 200 Nm + 270 degrees so are very tight to undo and must be held by a substantial holding tool which the kit provides. Also included in the kit are the puller component’s required to remove the pulley without damage. .
Feature: FUNCTION — This special rocker arm remover must be used to allow removal of the camshaft, rocker arms and hydraulic lash adjusters in 4.7 Liter Engines. The valve spring tool allows access at the valve keeper so a magnet can be used to remove it. BENEFITS — It’s a specialty tool to remove and install rocker arms safely without damage to the camshaft or camshaft lobes. REPLACE for Similar to the Miller 10102 that does the job of the 8426, 8387 and 8516A used for 3.7 and 4.7 Dodge engines. Rocker Arm Remover Installer & Valve Spring Compressor Tool Miller 8426, 8387, 8516A and 10102 for Chrysler, Jeep, Dodge 3.7 and 4.7 engines. Function: .
Description: 100% New and High Quality 1 Year Warranty Type: Body repair puller Material: Steel Color: Gold Capacity: 5 Ton/10000lbs Minimum Grip: 1-1/2″ Two way pull operation. Drop forged construction provides more pulling power and greater wear resistance. Self-tightening serrated jaws for a positive grip. Perfect to use in the confined space.Both side jaws are different in order to fit the confined room. Pulling Capacity: 5 Ton (straight way), 2 Ton (cross way) Minimum of 1-1/2″ reach-around for flanges, cowls, pinch welds and lips. Butts against panels where only narrow bite available. .
Feature: Inner Tie Rod Hex Wrench Square Socket Size: 13mm/1/2″ Suitable for tie rods between 27mm and 42mm in diameter. Specially designed to be used with 1/2″ square drive tools Fitment: Designed specifically for the removal of the direction of the steering rod. The master tie rod tools easily replace inner tie rod ends 27-42mm diameter without removing the rack and pinion Special design to be used with 1/2″ Square drive tools. Applicable to various vehicles: Mercedes Benz ,BMW ,Toyota , Honda ,Ford ,Nissan ,etc Package Include: 1x Tie Rod End Wrench Removal Tool .
